Permanent magnet magnetic separators are primarily suitable for ferromagnetic materials with weak magnetic field wet sorting fine particles, or remove strong magnetic mineral deposits in non-magnetic mineral deposits. When the slurry flows into the magnetic field, strong magnetic mineral deposits are adsorbed in the cylinder. On the outside, the weak magnetic and non-magnetic minerals were removed after sorting, and the strongly magnetic minerals adsorbed on the outer surface of the cylinder were taken out of the magnetic field with the rotation of the cylinder.
Inverted magnetic separator is used for dry separation of fine-grained (medium-strong) magnetic minerals. Because of the effect of high-speed rotation, the number of magnetic tumbling of magnetic particles is much higher than that of conventional magnetic separators. The progress of the enriched ore ratio has obvious effects. After being sorted, the ore deposit is separated into two kinds of magnetic and non-magnetic materials, which are discharged from their respective ore discharge ports, and are suitable for rough selection and fineness of ore with a grain size of 0.6-6mm. selected.
Now the cylinder type permanent magnet magnetic separator has been widely used. It has been approved and re-used by many users of iron ore processing. This model is suitable for removing iron from ilmenite, removing iron from hematite, removing iron from chromite ore, and rutile. Iron removal, monazite iron removal, lithium limestone iron removal, manganese ore iron removal, gold ore iron removal, antimony ore iron removal, and bauxite iron removal. It is an efficient and energy-saving mineral processing equipment, especially in the large production shows his unique superiority.