Apr 19, 2018

Daily maintenance and maintenance of electric drum

Leave a message

Daily maintenance and maintenance of electric drum

1.   Routine inspection of surrounding environment, fastening bolts, oil leakage, and cable integrity before each start shall create conditions for normal operation.

 

2. Every time you start, you should start with a jog and gradually turn into normal. After running for 10 minutes, check the vibration, noise, and the temperature rise of each running component.

 

3, if the electric roller oil leakage occurs, pay attention to check two parts: First, the oil seal, is not with the wear or deformation, wear can seal the lips of the oil seal ring, the wear volume of large oil seal Leakage can be solved. If it is invalid or deformed, it should be replaced in time skeleton oil seal; Second, the outlet channel cannot be blocked, as soon as possible to remove the deposition of dust, oil and debris, to ensure smooth access.

 

4. Replacement of cooling oil. The first oil change time is 10 days, the second time is 1 month, and oil is changed once every three months. For grease-filled parts, such as motor bearings for outer drums and output shaft support seats for cyclical rollers, frequent refueling should be done. Normally, they should be added once a month, and new oil should be replaced every six months.

 

5. The backstop used by the high-speed shaft of the exterior drum is generally cooled and lubricated by the cooling lubricant inside the cylinder through the internal passage. To prevent the shortage of oil, the top of the backstop is added With pressure cups installed, when the backstop heats up faster, it should be filled with the appropriate amount of oil from the cup. The number of times of filling should not be too high. It is advisable to use three to four times a month. Grams. The backstop should act as a backstop, otherwise the backstop will be damaged.

 

6. If there is no special situation, the drum does not generally require maintenance, but normal maintenance should be performed. Every six months, a small maintenance, cannot remove the cleaning cylinder internal gear (cycloid or planetary) and the support and operation of parts and replace the cooling lubricant fluid. Maintenance once a year, dismantle the bearing, end cap, cylinder, cleaning the inner wall of the cylinder and the transmission body, check the wear of gears, cycloids, and bearings. Check the position of the force, whether the keys, keyways are deformed, and whether the oil seal is worn or not. Big maintenance once every two years, disassemble all parts, check, repair or replace. All oil used for oil-immersed drum motor should be used strictly according to the specified oil type in the instruction manual. Users are not allowed to change the oil type to prevent the motor from being burned out.

 

7. Periodic inspection of the oil level in the drum is an important part of routine maintenance. The specified oil level is one of the conditions for ensuring the normal operation of the drum. The inspection method can be checked according to the method described in the instruction manual. With the adjustment and maintenance of electric hydraulic block brakes and the maintenance of hydraulic couplings, please follow the instructions for use of the product.


Send Inquiry