Pipe Magnetic Iron Remover Use Maintenance Instructions
1. Before starting the machine, the operator must open the observation cover to check whether there is a large iron piece on the partition plate (especially the tap hole) of the iron separator. If yes, it must be cleared to boot.
2. Once a mechanical failure occurs in the machine, and the production line temporarily stops inconvenient, the power of the machine can be shut off. The operator can remove the mixed iron from the observation port and the production line can continue to work. But at the same time, it should be timely repaired with professionals, non-professionals are not allowed to open the lid, so as to avoid damage to the parts. Every time before closing, it must be sealed with an oil sealant.
3. should remove the dust on the gear motor in every class; add calcium-based grease once every six months to the gear hole of the geared motor and the side chain; replace the oil in the oil groove at the bottom of the chassis every twelve months if the material temperature is higher than 100 °C, shorten the oil change time.
4. the machine side sprocket cover felt and large sprocket under the felt in order to ensure that the chassis seal and effective breathing, repair cannot be damaged; felt rings after long-term use and wear should be replaced.
5, if the powder small particles (≤1mm) ferromagnetic content is high. There is an increase in the amount of powder entrained in the exit of the tap. This is a normal phenomenon.