May 16, 2018

Several Factors Influencing Iron Removal Effect of Electromagnetic Iron Remover

Leave a message

Several Factors Influencing Iron Removal Effect of Electromagnetic Iron Remover


In coal-fired power plants, the inclusion of iron is not only easy to damage the conveyor belt, but also damage the coal mill, especially the current use of more speed mill, more sensitive to iron, once the iron into, Can easily cause damage to parts. Selecting the proper iron remover and installing it properly can greatly reduce the cost of equipment purchase and installation and improve the iron removal effect.

1. Effect of temperature rise of iron remover on iron removal effect

The magnetic field intensity is proportional to the current, and the current is inversely proportional to the resistance, and the resistance of the energized coil increases with the increase of the temperature. Therefore, as the energization time is extended, the temperature of the energized coil rises and the resistance thereof increases. The corresponding current will decrease, resulting in a weakening of the magnetic field until a dynamic equilibrium is reached. Therefore, the good cooling effect of the electromagnet is an important factor in keeping its field strength from drastically weakening. One is to use a good iron remover with good heat dissipation effect; the other is to use double dust collectors arranged in turn to cool down in time, avoiding iron removal by intermittently removing iron from the iron separator during unloading.


2. The effect of iron parts near the magnetic field of the iron remover on the iron removal effect

Electromagnetic iron remover is a complex physical process, and the iron removal effect will be affected after the iron is magnetized around the iron separator.


3, the effect of coal thickness on iron removal effect

The iron remover removes the iron from the coal on the conveyer belt, and must overcome the weight of the iron piece, the gravity of the coal layer on the piece, the friction force of the layer to the iron piece, and the additional attraction force of the magnetized iron object in the field to the iron piece. The closer the iron piece is to the magnetic pole of the disk, the greater the suction force and the smaller the other negative effects. Therefore, to keep the field strength of the iron piece not falling, it is better than the required field strength to suck the iron piece from the coal layer. It is much smaller, so in order to control the temperature rise of the electromagnetic iron separator and save energy at the same time, a metal detector can be installed before the iron remover. When there is iron in the conveyor belt, the metal detector signals the iron remover so that strong magnetic force is generated in the iron remover and the iron is sucked up. 


In normal circumstances, the electromagnetic iron remover only needs to generate a magnetic field that ensures that the iron pieces do not fall off. In order to ensure the reliability of the metal detector, the two detectors can be used in parallel. As long as one detector detects the iron piece, strong magnetism is immediately generated in the electromagnetic iron remover.


In the thermal power plant, the configuration of the iron remover is getting higher and higher, the cost of related equipment and buildings has been greatly increased, and the energy consumption of the iron remover has also increased dramatically. Therefore, the use of the iron remover has been studied in depth and its iron removal effect has been improved. It is necessary to find a proper balance between magnetic field strength, application and energy consumption.


Send Inquiry